Prototype #2

 The second prototype had a similar design to the first prototype. Of course, it was adjusted to allow for the current to actually flow into it. The current would flow through the wires holding the commutator,  which would apply the current. This supplying current would allow for the commutator to spin upward and fall back down due to gravity in a continuous pattern. This system was not complex and required little thought/parts.




This motor only ever managed to slightly twitch. This is due to the power source i was using, a 9 volt battery, which managed to run out of power fairly quickly. This was also due to the design of the motor as a whole, I was much to flimsy, and the commutator was much to heavy, so this system of motor i had come up with was only ever going to work after a couple prototypes, and would be a nightmare to deal with due to the pre exclaimed flimsiness.


Final Result : Magnetic force felt

                     : Twitched a little

Comments

Post a Comment

Popular posts from this blog

Physics Motor Entry #1

Preview Mode To Be Used On Every Slide  The Creation of a Electro-Magnetic Motor The creation of my motor showed many stages of development. I believe these stages to reflect the amount of knowledge I had on the practicalities of creating a motor. But before getting into the electric motor, we must learn its background the first rotating device driven by electromagnetism (electric motor) was constructed by the Englishman Peter Barlow in 1822 (Barlow's Wheel) . The first practical application of an electric motor was created in 1835 by two Dutchmen named Sibrandus Stratingh and Christopher Becker, near the birth of electricity. The first known application of the motor, was for a small model car in 1837. The electric motor today, is used in many home products. Cameras for there shudders, fans to create motion and new, climate saving cars use electric motors to create motion. the creation of electric motors seems so complex and deep so the question stands, is it possible to create a
Read more

Prototype #4.5

Image
<-- recreation (initial image not found)  Prototype 4.5 was the near to the final creation. I created it with the right hand rule in mind. The direction of the current would dictate the direction the axel would move in. This prototype was created to be sturdy and hold the wire in place while stimulating the force needed to create movement This also managed to update my risk assesment as the current it created managed to melt the wire i was using and fuse it to the glove I was wearing to protect myself from the super glue and heat. Prototype #4 was not a success due to my finding that the boxes coils went against the magnetic field, meaning i had to rethink my design once again. Results : Heaviy magnetic force No spin 
Read more

Prototype #3

Image
 After a long period of stagnation I came back to the motor project with fresh eyes. A new out look on how the motor should be made. I wanted a sturdier frame so I didn't have do deal with movement that came from minuscule lapses in movement that would completely destroy Mark 1 and Mark 2. Mark 3 of the motors was a complete over haul of my initial plan for the motor this was due to my study on theoretical ideals of the motor, particularly the equation F = I*l*B. Increasing the length of my coils would inevitably increase the force, I also decided to change my magnets to stronger ones that would create a stronger magnetic field, and I changed the power source I was using and the amount of coils to increase the amount of current. All of these changes were done to create a stronger force The new motor was a new prong design. The 2 prongs were connected to the axel in order for the force to be forced side ways with the magnetic field.  At the time i believed the issue to be that the
Read more